24 15f21-28 19 33 78.9 No. Result test that performed by Sll Anchoring depth (cm) Location of failure Pull out loads tested with concrete strength 37.5 MPa Bore hole (mm) Pull out force (kN) מק״ט בדיקת שליפה שבוצעה ע״י מת״י עומק עגינה מיקום הכשל עומס שליפה נבדק עם בטון 30 ב- מגפ״ס) 37.5( קוטר קידוח (ס״מ) כוח שליפה קוביית הבטון נבקעה Anchoring a tie rod ( DYWIDAG) to a concrete wall DYWIDAG Metal Expanding Shell עיגון מוט קשירה (דיוודג) לקיר בטון מיתד עיגון מפלדה לדיווידג - מפרט 15F 2128 Instructions: 1. Drill a borehole according to the shell’s Dia. (32-34mm). 2. Clean the borehole 3. Screw the tie rod in to the cone of the Exp. Shells as the safety ring must remain on Exp. shell 4. Remove the safety ring 5. Insert the anchor into the bore hole 6. After insertion of the anchor screw the bar by hand until the anchor is fixed and cannot be moved further. During tightening of the screw extends the Shell in the hole and creates pressure on the sides of the hole, this Pressure avoids from it to pull out. Data sheet: Attention!! The following values can only be regarded as estimations for the real pull out loads therefore recommends to perform pull out test on site The anchor behavior depends very much on the quality of the concrete or rock as well as the size of bore hole therefor to perform pull out test on site. הוראות עבודה: מ״מ) למיתד 32-34( . קדח חור בקוטר המתאים 1 . נקה את חור הקידוח 2 . הברג את מוט ההברגה לקונוס של המיתד כשטבעת 3 האבטחה חייבת להשאר על המיתד . הסר את טבעת האבטחה 4 . החדר את העוגן עד סוף הקדח שם יעצר 5 . לאחר העצירה, סובב את ידית הבורג עד הידוקו המלא. 6 עם הידוק הבורג מתרחבת מעטפת המיתד בתוך הקדח ויוצרת לחץ על דפנות הקדח, לחץ זה מונע את שליפתו. נתונים טכניים: לתשומת לבכם!!! ניתן לראות את הערכים הבאים רק כהערכות לעומסים האמיתיים ולכן, מומלץ לבצע בדיקת שליפה באתר. תפקוד העוגן תלוי במידה רבה באיכות של הבטון או הסלע, כמו כן גם גודל של חור הקדח ולכן מומלץ לבצע בדיקת לשליפה באתר.
RkJQdWJsaXNoZXIy MjgzNzA=